09-02-2002 04:14 AM - edited 03-12-2019 08:35 PM
Hi, I have a 3Com NBX PBX and i have to connect this to Cisco ATA 186/188
Can i do this?
Wath i need for this?
Regards.
Solved! Go to Solution.
09-04-2002 06:53 AM
You need to connect fxo to fxs. So using a trunk port on the NBX to connect to a vic-2fxs should work.
Vance
09-04-2002 05:50 AM
Hello,
I've never worked with an ATA186 yet, but I understand it supports h.323. If you buy the NBX h.323 module and load it on a server, you should be able to pull this off. However, it would probably just be cheaper/easier/better to just implement one of 3Com's little ATAs...
Why this specific configuration?
Good luck,
Vance
09-04-2002 06:47 AM
The scenario can change.
NBX -- FXO -- 1751 --- WAN
but i looking for all solution posible-
Can i connect NBX-FXO cards to VIC-2FXO on 1751 Router?
09-04-2002 06:53 AM
You need to connect fxo to fxs. So using a trunk port on the NBX to connect to a vic-2fxs should work.
Vance
09-04-2002 07:51 AM
but i can make call in both way?
I hear that ATA connected to PBX only receive calls.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide