6608 and NM-HDV ..

[marinaibm]

Hi,

My customer wishes to implement connectivity from PSTN to 6608 blade on 6506 swicth .But this can be done only after 6608 homologation in Israel (it will take about a month ).The temporary solution is a 3662 with HDV adapter (Several ISDN-PRI ports).

My question is if the 3662 can be used as a front to the 6608, the voice will enter the 3662 by the HDV, port 1, then go out by HDV, port 2 into the 6608.What are the disadvantages of this configuration ?Is it supported by TAC?

Thanks in advance

Marina

[ciscomoderator]

Since there has been no response to your post, it appears to be either too complex or too rare an issue for other forum members to assist you, or there is no public information available at this time. If you don't get a suitable response to your post, you may wish to review our resources at the online http://www.cisco.com/go/solutions. You may also contact our product information line at 1-800-553-NETS or a Cisco Systems Engineer at your local Cisco office or reseller. To locate your local Cisco representative, visit http://www.cisco.com/warp/public/687/Directory.shtml

If anyone else in the forum has some advice, please reply to this thread.

Thank you for posting.