06-21-2004 08:50 AM - edited 03-13-2019 05:20 AM
I'm trying to setup an audio conference on a Polycom MGC100 with a Cisco Ata186. I can dial out to the Ata using the IP address and the Ata will answer but it disconnectes after 30 seconds. Has anyone else tried this and if so what were your results? Thanks.
06-25-2004 10:18 AM
Not sure if this has something to do with the DTMF delay.
07-02-2008 11:52 PM
Hi dmeersman , do you have slove your problem? I met the same problem as yours in CCM5.1.2
Regards!
JOJO
07-11-2008 06:25 AM
I have the same problem as well with CM 6, however my calls last about 30 minutes then disconnect.
Has anyone found a solution?
11-10-2008 09:39 AM
I am having the same problem...any help?
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide