ATA or FXS, Fax questions

[jolo07310]

Orignally, we tried to use ATA for fax. However, it seems does not work with Canon eCopy (Fax module install in Canon eCopy).

I am not sure super G3 cause the problem or not.

I am thinking to order VIC2-2FXS or VIC-4FXS/DID and connect to Fax board in Canon eCopy.

Are those VIC2-2FXS or VIC-4FXS/DID support Super G3 fax???

Thanks

Ken

[DRAGI RADOVANOVIC]

Ken,

ATAs have issues with speeds higher than 14400. Use an FXS whenever you can for your faxes. I am not sure about the 4 port fxs/did support on the 2800s (if you have one).

Dragi

[aalejo]

Are you using fax-passtrough?

ATA does not support fax relay and H323 gateways comes with fax relay by default.

If you are using MGCP Gateways you should configure MGCP modem passtrough using nse.

Alex