05-16-2002 07:46 AM - edited 03-12-2019 06:51 PM
Can you integrate Call manager with Intuity Audix voice mail?
I am not thinking about integrating Unity with Audix, but using Audix as the native voice mail with CM. I imagine SMDI and analogue ports are the only way to do it, but I would appreciate any suggestions or experiences of having tried to do it.
Many thanks
Tim
05-22-2002 02:31 PM
Often times complex troubleshooting issues are best addressed in an interactive session with one of our trained technical assistance engineers. While other forum users may be able to help, its often difficult to do so for this type of issue.
To utilize the resources at our Technical Assistance Center, please visit http://www.cisco.com/tac and to open a case with one of our TAC engineers, visit http://www.cisco.com/tac/caseopen
If anyone else in the forum has some advice, please reply to this thread.
Thank you for posting.
07-12-2002 06:29 AM
I have successfully integrated Intuity Audix with CM. I used a VG248 gateway with the SMDI link and 4 analog ports. It works well...so far we have about 10 test users. The message waiting light works fine, etc.
Rob.
08-30-2002 03:25 PM
Rob
Can you please provide me with the information about the version of the Audix system with which you have tested the config.
Regds
Uttaran
10-16-2002 05:50 AM
You had mentioned in you previous post that you had 10 test users. How is it going now?
We currently link to the G3 via a H.323 using the clan card in the Avaya. Can any one tell me if this configuration will will allow me to light the MWI light on a Cisco phone if I forward the call to the G3 and use its current existing analog trunking to the Audix.
7960 ----> CCM ----> H.323 ----> CLAN----> G3 ---> Analog ---> Audix
or must I use the following.
7960 ----> CCM ---> VG248 ---> analog ----> Audix
.......................... \----------------SMDI-------------------/
Also can you share you configuration on the audix and CCM for us?
10-31-2002 12:11 PM
You had mentioned in you previous post that you had 10 test users. How is it going now?
We currently link to the G3 via a H.323 using the clan card in the Avaya. Can any one tell me if this configuration will will allow me to light the MWI light on a Cisco phone if I forward the call to the G3 and use its current existing analog trunking to the Audix.
7960 ----> CCM ----> H.323 ----> CLAN----> G3 ---> Analog ---> Audix
or must I use the following.
7960 ----> CCM ---> VG248 ---> analog ----> Audix
.......................... \----------------SMDI-------------------/
Also can you share you configuration on the audix and CCM for us?
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide