Calling Name with CM and NEC 2400

[iptelguy]

Has anyone been able to get calling name to pass in both directions between a CM and an NEC 2400? Using QSIG I can get calling name to display on the Cisco phones (NEC to CM). Using NI2 I can get the name to display on the NEC phones (CM to NEC). CM is version 3.3(3).

[dandon]

I can not get it to work either way with QSIG. I am running J3.21 on NEC 2400ICS and 3.3(3) on Call Manager. Could you help with the QSIG part? Any tricks to getting this?

Thanks,

Dane

[dandon]

Here is what I was just told by a Cisco/NEC dealer who has this working with QSIG.

The 3.3(3) needed a patch (Special Engineering Load) which Cisco provided them. The scenerio is this:

With QSIG, the name display works one way. When the NEC sends its QSIG ISDN setup information, there is a field that come across as as 090F (hex). NEC