cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Announcements
216
Views
0
Helpful
2
Replies
Highlighted
Beginner

CAS T1 Passing ANI MGCP

Greetings,

I am trying to get ANI to pass from a gateway to CRS apps. Configuration is CCM 4.1(3)sr2, 2821 w/2port MFT doing MGCP IOS 12.3-14T5.

I looked at URL http://www.cisco.com/en/US/products/sw/iosswrel/ps1834/products_feature_guide09186a008007fe27.html#17692 as a possible option, but my gateway doesn't support e&m-fgb.

I also looked at http://www.cisco.com/en/US/products/sw/iosswrel/ps5207/products_configuration_guide_chapter09186a008020ecf6.html#wp1042209 but when I tried to use e&m-fgd, I received either silence or dialtone and direct-inward-dial didn't help.

Any suggestions would greatly be appriciated.

Best Regards,

Craig

1 ACCEPTED SOLUTION

Accepted Solutions
Highlighted
Cisco Employee

In order to receive ANI on a T1 CAS circuit you need to use "type e&m-fgd" on the 2821. Unfortunately, fgd isn't supported with MGCP and CallManager.

View solution in original post

2 REPLIES 2
Highlighted
Cisco Employee

In order to receive ANI on a T1 CAS circuit you need to use "type e&m-fgd" on the 2821. Unfortunately, fgd isn't supported with MGCP and CallManager.

View solution in original post

Highlighted
Beginner

You will have to configure the router as H.323 to support caller id on a T-1.

Content for Community-Ad