Cat4K AGM DSP Provisioning via the CLI?

[jhatfield]

I have a customer using a Cat4K AGM in IP Telephony mode. They are not utilizing the conferencing or transcoding features and would like to allocate those reserved DSP resources for more voice channels. Anybody out there using a 12.2x IOS version that can change the DSP allocation? I haven't found one yet that works in IP Telephony mode. Thanks in advance.

[#2]

This is definitely possible. You can allocate the DSP resources for more voice channels. I have a link to a document, with more explainations on it as given below.

Catalyst DSP Provisioning

http://www.cisco.com/univercd/cc/td/doc/product/voice/ip_tele/network/dgcatdsp.htm#xtocid1326011

WS-X4604-GWY: Access Gateway Module (AGM) for Catalyst 4000 Series Switches

http://www.cisco.com/en/US/products/hw/modules/ps2797/products_tech_note09186a00800e6708.shtml#fourth