12-30-2001 08:02 PM - edited 03-12-2019 01:52 PM
I have T1/PRI can be dial in/out.
when I dial in,I can use debug mode at my as5300.
can show my telephone number,
can I check my telephone number to determine my as5300 dial-peer rule.
what's mean about this command
"calling-number outbound sequence"
can I use this command ..
01-02-2002 06:55 AM
To my knowledge there is not a way to route the call based on the calling party. I work more with 26xx/36xx and Call Manager than I do with the 5300, but I did not see anyone answer your questions.
Thank you,
-Mckee
01-02-2002 07:59 AM
If you are using CallManager, you can always use partitions and route lists to accomplish this.
01-02-2002 04:58 PM
How can I do this command at my CCM.
I want to use AS5300 to another AS5300.
because I want use from AS5300 dial in, another AS5300 dial out.
When Call setup, we can check call setup/alert/connect parameter value, we can check it to choose specify route.
so Have somebody can help me to use.
01-03-2002 12:36 AM
Hi,
Try to use answer-address feature. It will solve ur purpose. Also go thru the following site. It is useful...
http://www.cisco.com/warp/public/788/voip/in_dial_peer_match.html
pchepurthy
01-03-2002 12:57 AM
thanks your suggest.
but I had tried about command for answer-address before,
but no any help.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide