Hi
I have new CISCO2911/K9 router and installed VIC2-4FXO on it, I can see all 4 ports are orange lighting, I need to configure 2 ports connected to PABX and other 2 ports to PSTN, I have the config from other router, but the issue is when I type command "voice-card 0" it says invalid command.
I tried to change the licnese from default ipbase to uck9, the command "voice-card 0" worked but other command"voice-port 0/3/0" not working, so do I need to type command that activate FXO module and which license/image should I use in-order to configure the voice ports (you can see below config example from another router running perfectly).
show version shows these licenses and image:
c2900-universalk9-mz.SPA.154-3.M3.bin
Technology Package License Information for Module:'c2900'
------------------------------------------------------------------------
Technology Technology-package Technology-package
Current Type Next reboot
------------------------------------------------------------------------
ipbase ipbasek9 Permanent ipbasek9
security None None None
uc None None None
data None None None
NtwkEss None None None
CollabPro None None None
show inventory
NAME: "2nd generation four port FXO voice interface daughtercard on Slot 0 SubSlot 3", DESCR: "2nd generation four port FXO voice interface daughtercard"
PID: VIC2-4FXO , VID: V03
Config example:
voice-card 0
voice service pots
!
voice service voip
fax protocol none
sip
min-se 90 session-expires 90
session refresh
no call service stop
!
voice-port 0/3/0
secondary dialtone
no battery-reversal
timeouts initial 8
timeouts interdigit 5
timeouts call-disconnect 1
timeouts ringing 5
timeouts wait-release 2
timeouts power-denial 5
description 2-wire analog connection to PABX
station-id number xxxx
!
voice-port 0/3/1
secondary dialtone
no battery-reversal
timeouts initial 8
timeouts interdigit 5
timeouts call-disconnect 1
timeouts ringing 5
timeouts wait-release 2
timeouts power-denial 5
description 2-wire analog connection to PABX
station-id number xxxx
!
voice-port 0/3/2
secondary dialtone
no battery-reversal
timeouts initial 8
timeouts interdigit 5
timeouts call-disconnect 1
timeouts ringing 5
timeouts wait-release 2
timeouts power-denial 5
description PSTN
station-id number xxxx
!
voice-port 0/3/3
secondary dialtone
timeouts initial 8
timeouts interdigit 5
timeouts call-disconnect 1
timeouts ringing 5
timeouts wait-release 2
timeouts power-denial 5
description PSTN
station-id number xxxx
!
mgcp profile default
!
!
dial-peer voice 20 voip
destination-pattern x....
session protocol sipv2
session target ipv4:x.x.x.x
dtmf-relay sip-notify
codec g711alaw
no vad
!
dial-peer voice 2 pots
description PABX connection
destination-pattern x[0-9].....
port 0/3/0
forward-digits x
!
dial-peer voice 3 pots
description PABX connection
destination-pattern x[0-9].....
port 0/3/1
forward-digits x
!
!
sip-ua
keepalive target ipv4:x.x.x.x
keepalive trigger 10
retry bye 5
retry keepalive 5
retry options 5
timers keepalive down 15
timers keepalive active 15
timers options 300
!
!
!
gatekeeper
shutdown
