cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
567
Views
0
Helpful
3
Replies

CiscoOS and CM Installation w/o network

Hi,

Can any problem to occur while-and-after I'm installing Cisco OS and CallManager 4.2(3)

on the MCS that currently doesn't have network connection (no network cable plugged into

the MCS's NIC1).

When I'm writing the word 'problem', I mean the influence might take place

for finally installed Cisco OS and CallManager configuration, i.e. the unpleasant

things could be avoided, if I install the Cisco OS and CM while MCS is connecting to

the corporate net ?

1 Accepted Solution

Accepted Solutions

Rob Huffman
Hall of Fame
Hall of Fame

Hi Tobivan,

Hope all is well!

We just did an exact CCM 4.2(3) build in the lab (not connected to the Campus Network) before going live without any issues :) You will want to to connect to a lab switch, especially for building any Subscriber boxes (db replication) but other than that you should be good to go.

Hope this helps!

Rob

View solution in original post

3 Replies 3

Rob Huffman
Hall of Fame
Hall of Fame

Hi Tobivan,

Hope all is well!

We just did an exact CCM 4.2(3) build in the lab (not connected to the Campus Network) before going live without any issues :) You will want to to connect to a lab switch, especially for building any Subscriber boxes (db replication) but other than that you should be good to go.

Hope this helps!

Rob

Thank you, Rob.

I've actually checked this today. All is fine.

Hi Tobivan,

You are most welcome my friend :) Glad to know this didn't cause you any problems either.

Take care,

Rob