03-20-2006 05:38 PM - edited 03-15-2019 04:11 AM
Hi All;
I set clock on CME and configured it as NTP master. but the clock in CUE has not been changed. How can I force clock configuration from CME to CUE?
thanks
Alex Goshtaei
Peak Technology
03-20-2006 05:43 PM
Alex,
Have you set the CME router as NTP server from the CUE box ? Are you able to ping the CME ip address from CUE ? Make sure you have a static route in CME for CUE's ip address, pointing to the serviceengine interface.
Sankar
PS: please rate the post if it helps!
03-20-2006 09:17 PM
Like Sankara mentioned, you'll need to setup your CME router as a ntp master. Then you will need to access you cue module.. service-module service-engine 0/x session. Once logged in you will need to go to config mode and type ntp server "ip address of router". Make sure you can pig that address from the CUE module.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide