Folks, We have a brand new 3825 router which has 2mft1 controller card in slot 0/1, but the router IOS does not see it. We are running advanced ip services in the router.I tried using the command, "card type t1 0/1" but it does not work.Pleas...
When our VoIP was set up a few months ago, IPMA was configured and test although we're not actually using it. I had a need recently to replace a user's phone and happened to use the phone that IPMA was tested with that had the "bell" icon on it. Ho...
Hi All;I set clock on CME and configured it as NTP master. but the clock in CUE has not been changed. How can I force clock configuration from CME to CUE?thanksAlex GoshtaeiPeak Technology
After integrating Callmanagers to Active Directory (1000 users), how can we return to DC Directory?Is there any tools to disable AD, Renable DC Directory and migrate the users from AD to DC?Or we have to ReInstall the CallManager and after use some t...
Can someone explain or point me to a resource that outlines "in detail" what the ccm-manager config command does?I know it "downloads an XML file" from the CM but specifically what is in the XML is a mystery to me.
Has anyone or does anyone know of a E911 call center using SS7 trunks on a Call Manager. We are a small city in Illinois with Call Manger installed for city wide use. Our powers to be would like to add our PSB onto our Call Manager. I have read that ...
Need some Assistance! I'm trying to convert or mark my VoIP packets on my router for my VoIP packets from 6 to 5. Need some assistance on how I should accomplish this. My ISP only identifies 5 for VoIP. How can I mark the packets to 6 on inbound inte...
When is it necessary to have multiple Cisco Call Manager Clusters. The only necessity I would think is when a client has more than 30,000 IP Phones requirements. Is it beneficial to have multiple Call Manager Clusters other than IP Phones more tha...
hi we have call manager 4.1 , i have installed a asterixsip serevr with sip phones.iam able to call from cisco to non cisco and visa versa.but this only possible when i set the codec fo cisco phones as g.711.it is not working when i change it to g.72...
I have a user that has shared line on her 7914 that are set to flash only. If she goes off hook to make a call and a shared line is flashing she answers that call by mistake.How do I keep this from happening.
What are the procedures of migrating personal address book from dc directory to ms ad? this is because when i did ad integration, the pab still resides in the dcd.
Do we have to turn on the cDR true on service parameter for subscriber, if all the devices are registered on sub as primary? I always only enable true for pub and that seems works. But recently came across a doc indicates that cdr true needs to be on...
Hi all. I have problem with "hold" feature on CCM 4.1(3)SR3. Pressing HOLD softkey during active call cause disconnect of call.I tried to debug (debug voice ccapi detail) this situation on voice GW (see attach) and received " DisconnectText no resou...
