Connecting 6608 E1 to Dialogic D/600JCT-2E1

[vk]

I have tried to connect 6608 E1 to Dialogic D/600JCT-2E1 using CCM 3.1(1) with 6506 MGCP Gateway with no luck - always get red light and status "notconnect"

Can anyone tell me how the Gateway Configuration page in the CCM should look like ?

Thanks in advance,

Vidir

[mimckee]

I have never connected to a card like that but I would suspect that you would need a E1 crossover cable to get this to work. Did you use a straight through cable or a crossover?

Thank you,

-Mckee

[vk]

Hi Mckee and thanks for your reply.

I have tried to use both cat5 crossover and straight cables without luck - always red light and the 'notconnect' status.

thanks,

Vidir