12-29-2005 06:35 AM - edited 03-13-2019 11:41 AM
I just installed Cisco CM 4.0(1) and that works. After that I installed Cisco CRS 4.0(1) on the same server. Istallation was OK, but when I restarted server, and try to log on to Application Administration (CRS Web page), to do initial setup of CRS Application, I could not log on, the message on the screen was "You are not authorized to wiev this page". And now I don't know what to do, I can't start CRS Application. Help needed.
12-29-2005 07:33 AM
Zemo,
there are few things that might've gone bad. Look at this link for answers:
http://www.cisco.com/en/US/products/sw/custcosw/ps1846/prod_tech_notes_list.html
Pozdrav,
Dragi
12-29-2005 11:53 PM
Ne pomae, ima ista greka na site-u, trebao promijeniti dozvole na nekim userima, ali je to već bilo namketeni kako treba, tako da ću ga morati ponovno instalirati.
Hvala.
12-30-2005 05:59 AM
Username administrator je case sensitive. Moras ga ukucati, ako se dobro sjecam, sa velikim A.
Dragi
01-06-2006 09:44 AM
jesi li uspio?
Dragi
01-09-2006 12:30 AM
ma nisam, skinut ću ga ponovo.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide