Buy or Renew
Buy or Renew
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation
224
Views
0
Helpful
1
Replies

Dialogic on OLD 2.4.120 Unity/ WinNT4.0

b.carnot
Level 1
Level 1

‎02-24-2004 02:46 PM - edited ‎03-13-2019 03:58 AM

This Unity system has a Dialogic D/41ESC board in it, and is connected to a Calista unit to a Mitel SX2000.

Well, Unity is not seeing the ports.

I had problems getting the NT4 system to see the board. I installed the Dialogic System software 5.1.1 from Dialogic.

I now seem to remember that it has to be installed by unity in-order for it to be seen. Is that correct?

Thanks so much.

Brett

Labels:
0 Helpful
1 Reply 1

eschulz
Cisco Employee
Cisco Employee

‎02-24-2004 05:04 PM

The Dialogic installation software shipped with Unity uses several custom files (the TSP for example) which are either not present or significantly different than what you'd find in the software package direct from Intel/Dialogic. So while it is possible to install the Dialogic software independent from the Unity installer, you really do need to use the Dialogic package included with Unity.

-Eric

0 Helpful
Customers Also Viewed These Support Documents