Digit strip in 12.4XC4

[paolo bevilacqua]

[pls excuse duplicate post]

I thought that the main usage of digit strip was to remove the matched pattern for an outbound pots call.

I run 12.4.XC4 with CCME 4.0(3), digit strip on a destination pattern of ^0T is not removing the 0 and passes the dialed number unchanged to a BRI voice port.

I had to use a translation rule to remove the leading 0.

Did I misunderstood the usage? How can check that digit strip is working or not when dialing out ? Calls are made from skinny phones.

[msolak]

hi,

why you are using ^0T as destination pattern?

try it with 0T and the 0 will be stripped.

you needn't use any translation pattern to strip the leading 0.

regards

mehmet