Re: DSP config in Router with Etherswitch

carijit · ‎12-20-2004

Hi,

WE have a Router with a Ether switch at one of our branch office.

The etherswitch connects the IP phone and the router is connected to the mail office over FR.

If I want to configure DSP resources in the router which Mac Address should I use to register it to the Main site Call Manager.

Loopback MAC or Serial Interface MAC.

Any help wll be appreciated.

Thanks

icabrera · ‎12-21-2004

When you configure the DSP resources, you enable de sccp protocol and there is a command "sccp local interface x" you have to configure.

Use the MAC of the interface referenced with this command.

I think it's better using the loopback interface.

You can see the next url:

Regards