09-15-2004 01:27 PM - edited 03-13-2019 06:22 AM
Hi:
I have a centralized call mgr (4.0) with ip phones at a remote site The remote site has a 2651xm pri gateway. The 2651 has a nm-hd-2ve module with 1 mft-t1.
I've been told that I can use the spare dsp's in the 2651 as a conference resource for the remote ip phones.
Does anyone know how to configure the 2651 & cm to do this?
thanks
Rob
09-15-2004 03:37 PM
What PVDM2 chip do you have ? Note that PVDM2-8 does not support conferencing. Check this link to find out how to do conferencing based on PVDM2 on NM-HDV2.
Hope that helps!
09-15-2004 06:00 PM
Looks like just what I need.
How can I tell which PVDM I have in router?
Thanks a lot.
Rob
09-15-2004 09:35 PM
I answered a similar question in detail in another post:
You don't have any PVDM's installed in the router. The NM-HD-2VE has a single DSP soldered on the motherboard without any PVDM slots.
You can use one of the following commands to determine the DSPs installed in your router (depending on IOS version):
sh platform
sh diag
sh voice dsp
sh voice dsp detail
sh call resource voice stats
Hope this helps...
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide