05-22-2003 10:46 AM - edited 03-12-2019 11:59 PM
Hi I have the follow card VWIC-1MFT-E1 and I want to install it on a 2611 ,my question is I have to use the NM-HDV tray or can I use the NM-2v that I´m using with 2 FXO cards? I read that this is possible but , in practice ? Works fine ?
Thanks
05-22-2003 11:50 AM
A VWIC-1MFT-E1 is a digital card and must be used in a NM-HDV (High Density Digital Voice) module.
Your NM-2V card is an analog card used for analog VICs like FXO, FXS or E&M ports.
This url will give you what slots will support the VWIC-1MFT-E1
http://www.cisco.com/en/US/products/hw/routers/ps259/products_data_sheet09186a0080091b9c.html.
Depending upon the use the MFT card might be applicable in a normal WIC slot. This will turn it into a normal E1 usable for WAN connections. The voice capabilities will not be usable unless it's in a VWIC/HDV module.
05-22-2003 12:13 PM
OK thanks for the reply that minds that the MFT boards only use NMHDV to support Voice capabilities ? Because I read a document in the following link
http://www.cisco.com/en/US/products/hw/routers/ps259/products_data_sheet09186a0080091b9c.html and I understand that I can use the board with the chassis WIC slot or I`wrong ?
Thanks
05-22-2003 12:17 PM
You are correct, you can use them in a wic slot as an normal E1/WAN card.
If you would like to use it in a voice application you will need an NM-HDV.
05-22-2003 01:02 PM
Thansk for your reply you was very helpfull.
Now I understand perfectly.
Thanks again.
05-24-2003 07:51 AM
You can also use the card in a wic slot as a voice card. You need an
AIM-VOICE30 in the router also.
05-27-2003 12:40 PM
Here is additional info if you use the AIM card and the VWIC-MFT in a WIC slot 0 instead of the NM-HDV in slot 1:
05-27-2003 03:22 PM
So that means that can I use it in a VoIP application ? Its true ?
Thanks
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide