cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
1552
Views
0
Helpful
0
Replies

E1 R2 integration with Panasonic PBX

Wengkie Kuswendi
Beginner
Beginner

Hi,

I'm trying to integrate cisco H323 voice gateway 2951 with panasonic PBX using E1 R2.

Call from ip phone to PBX works well, but call from PBX's Analog Phone to Cisco IP Phone doesn't work.

When I debug voice ccapi, the calling and called number is empty.

The PBX is panasonic KX-TDA-100 with KX-TDA0188-XJ E1 module.

The module doesn't support PRI.

Here are my configuration :

!

isdn switch-type primary-qsig

!

controller E1 0/0/0

ds0-group 1 timeslots 1-15,17-31 type r2-digital dtmf dnis

cas-custom 1

  seizure-ack-time 30

  release-ack

  dtmf timer inter-digit 500

!

Configuration and debug is attached as below.

Any suggestion is deeply appreciated.

Thanks,

Wengkie K.

0 Replies 0
Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Recognize Your Peers