04-12-2012 06:20 AM - edited 03-13-2019 07:47 PM
i have a 3845 gateway added as h323 gateway on CUCM 8.
we i try to make an outbound call .
The system cannot complete the call.
"Your call cannot be completed as dialed Please consult your directory and call again or ask your operator for assistance "
when i opend a debug h245 on the GW i get the below output .
023334: *Apr 12 13:08:55.918: %C3800_ENVM-3-MFAIL_OFF: There is more than one fa
ilure with the Power System 2 or this Power System has been turned off.
023335: *Apr 12 13:09:15.918: %C3800_ENVM-3-MFAIL_OFF: There is more than one fa
ilure with the Power System 2 or this Power System has been turned off.
023336: *Apr 12 13:09:33.906: h323chan_chn_process_read_socket: fd=0 of type LIS
TENING has data
023337: *Apr 12 13:09:33.906: Changing to new event: ACCEPT
h323chan_chn_accept: fd=0
023338: *Apr 12 13:09:33.906: h323chan_gw_accept: TCP connection accepted from 1
72.19.0.141:40444 on fd=2
023339: *Apr 12 13:09:33.906: h323chan_chn_accept: Local(0x0) accepts TCP conn f
rom 172.19.0.141(0xAC13008D) port (40444); fd=2changing from LISTENING state to
ACCEPTED state
023340: *Apr 12 13:09:33.926: h323chan_chn_process_read_socket: fd=2 of type ACC
EPTED has data
023341: *Apr 12 13:09:33.930: h323chan_close: TCP connection from fd=2 closed
023342: *Apr 12 13:09:35.918: %C3800_ENVM-3-MFAIL_OFF: There is more than one fa
ilure with the Power System 2 or this Power System has been turned off.
can any one help ??
.
Solved! Go to Solution.
04-12-2012 07:27 AM
Then look at your H323 config and make sure you're matching a destination pattern on a DP and the DP is up.
HTH
java
If this helps, please rate
www.cisco.com/go/pdihelpdesk
04-12-2012 07:00 AM
Start by checking CSS/partitions on CUCM, then make sure you're matching a dial-peer on H323 and that the target (VOIP or POTS) is up
HTH
java
If this helps, please rate
www.cisco.com/go/pdihelpdesk
04-12-2012 07:23 AM
i think it is a Gateway issue not a CUCM issue .
i have check the CUCM by using DNA and here is the result .
04-12-2012 07:27 AM
Then look at your H323 config and make sure you're matching a destination pattern on a DP and the DP is up.
HTH
java
If this helps, please rate
www.cisco.com/go/pdihelpdesk
04-12-2012 08:09 AM
solved after adding the right destination pattern at the pots DP .
Thanks alot
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide