Gateway Tone-on-Hold volume levels

[tringwelski_2]

Does anyone know how to adjust the auto generated Tone-on-hold volume which is generated to the caller on hold over the pstn?

[jbohla]

Hello,

This is taken from Cisco documentation:

Adjusting the audio levels on the Cisco Access Digital Gateway DT-24+/DE-30+ requires the following software:

- Cisco CallManager release 2.3 or 2.4

- Cisco Digital Access load file D003G024.bin

- Cisco DickTracy utility

Steps to adjust the audio levels on the Cisco Access Digital Gateway DT-24+/DE-30+ using the DickTracy utility are given in this document.

http://www.cisco.com/en/US/products/sw/voicesw/ps556/prod_release_note09186a00800b7567.html

Thanks,

[tringwelski_2]

Thanks for the reply, I should have been more precise, I have an IOS gateway 26xx, 36xx and these are the types of gateways I wish to adjust the Tone-on-Hold volumes.

Regards,

Todd