cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
196
Views
0
Helpful
1
Replies

H323 and 2 different lines

lterebizh
Level 1
Level 1

I have configured H.323 gw...

With one line... it work OK....

I just fixed issue with codec type to be able call to Unity number...

This line have no caller ID....so I switched to another line...

And...

Now .. with the same configuration...I can see that call placed...number (caller-id) detected... BUT...

Call is immidiately terminated....

What is it?

Does anybody know...?

1 Reply 1

ciscomoderator
Community Manager
Community Manager

Often times complex troubleshooting issues are best addressed in an interactive trouble-shooting session with one of our trained technical assistance engineers. While other forum users may be able to help, it’s often difficult to do so for this type of issue.

To utilize the resources at our Technical Assistance Center, please visit http://www.cisco.com/tac and to open a case with one of our TAC engineers, visit http://www.cisco.com/tac/caseopen

If anyone else in the forum has some advice, please reply to this thread.

Thank you for posting.

Often times complex troubleshooting issues are best addressed in an interactive trouble-shooting session with one of our trained technical assistance engineers. While other forum users may be able to help, it’s often difficult to do so for this type of issue.

To utilize the resources at our Technical Assistance Center, please visit http://www.cisco.com/tac and to open a case with one of our TAC engineers, visit http://www.cisco.com/tac/caseopen

If anyone else in the forum has some advice, please reply to this thread.

Thank you for posting.