10-16-2001 02:55 AM - edited 03-12-2019 12:54 PM
We have a DID T1 Trunk line.We want to use RJ45 to connection with W6608 voice T1 blade. T1 DID HTU-R device has two pairs(in).I want to know what the pin number of RJ45 we should link together ?
10-16-2001 12:23 PM
The standard pairs - 1,2,4,5. Here is the guide for the card:
http://www.cisco.com/univercd/cc/td/doc/product/lan/cat6000/cfgnotes/78_10972.htm
If you were going to plug the 6608 port directly into the telco smartjack then you would just a standard straight-through cable.
10-16-2001 11:52 PM
Thanks Dave. It's still can't work.Link LED on Cat.6509 X6608-T1 blade is orange.Our T1 DID line is without D channel.
We got error message for Cat.6509 as below:
SCI XMT FAILURE
SCI HEARTBEAT FAILURE
And HTU-R shown local alarm and T1 alarm.
Does it may cause of x6608 or callManager spec. ?
Rgards
Chia-hsin Liu
10-18-2001 10:39 AM
Is the 6608 port registered to CallManager as a T1 gateway? If you look at show port x/y on the Cat does it show it as a T1 and that it's registered?
If it is registered and you are still getting the orange LED then it sounds like a physical layer problem.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide