Inmediate disconnect after CONNECT ACK

[jgomez]

I´m getting inmediate disconnect in outgoing calls

through 1751 with VIC-2BRI, 2 DSPs, 12.2(15).T11 and Spanish BRI lines. Configured as H323 gateway in CCM.

After receiving CONNECT ACK, I see Disconnect

with Cause: Information element not implemented.

Seems it isn´t able to get a B-channel.

I tried forcing Called Numbering Plan to Unknown

but no effect.

Line works fine when directly connected to an ISDN

phone.

This is part of the config:

interface BRI2/1

no ip address

isdn switch-type basic-net3

isdn incoming-voice voice

!

voice-port 2/1

compand-type a-law

bearer-cap Speech

!

dial-peer voice 2 pots

destination-pattern T

progress_ind setup enable 3

progress_ind alert enable 8

progress_ind progress enable 8

progress_ind connect enable 8

no digit-strip

direct-inward-dial

port 2/1

!

Any suggestions would be highly appreciated.

Thanks

Alvaro

[jgugler]

Hello

i have the same problem here with Switzerland line (basic-net3)

The configuration is ths same and I get the following :

May 14 08:54:19.449: ISDN BR1/0 EVENT: process_bri_call: call id 0x8018, called_

number 0313859874, Guid 1A61BD18805Aspeed 0, call type VOICE, calling_number 031

3859074

May 14 08:54:19.449: ISDN BR1/0 Q931: Applying typeplan for sw-type 0x1 is 0x0 0

x0, Calling num 0313859074

May 14 08:54:19.453: ISDN BR1/0 Q931: Applying typeplan for sw-type 0x1 is 0x0 0

x0, Called num 0313859874

May 14 08:54:19.453: ISDN BR1/0 Q931: TX -> SETUP pd = 8 callref = 0x14

Bearer Capability i = 0x8090A2

Standard = CCITT

Transer Capability = Speech

Transfer Mode = Circuit

Transfer Rate = 64 kbit/s

Channel ID i = 0x81

Progress Ind i = 0x8183 - Origination address is non-ISDN

Calling Party Number i = 0x0080, '0313859074'

Plan:Unknown, Type:Unknown

Called Party Number i = 0x80, '0313859874'

Plan:Unknown, Type:Unknown

May 14 08:54:19.537: ISDN BR1/0 Q931: RX <- RELEASE_COMP pd = 8 callref = 0x94

Cause i = 0x82E404 - Invalid information element contents

May 14 08:54:19.541: ISDN BR1/0 EVENT: process_rxstate: ces/callid 1/0x8018 call

type 2 HOST_DISCONNECT_ACK

[jgomez]

Are you using "compand-type a-law"?

I get a similar error when trying with

compand-type u-law.

[jgugler]

Congratulation, it works very well !!!!

Thanks a lot

[jgomez]

OK, could you please send me your config.

to see if it helps me with my problem?

My email is adiez@genetsis.com

Do you use the default value "CallManager" for

the Called Numbering Plan, etc?