09-12-2002 12:46 AM - edited 03-12-2019 08:44 PM
Hello,
Does anyone know why I haven't the command option:
isdn incoming-voice etc. while I'm in BRI interface mode?
I have the following:
Cisco 1760
VIC 2B-NT/TE (slot 1)
VIC 2FXS (slot 0)
IOS 12.2(11)T
(I do have a ougoing-voice ... -option)
Thanx,
Rob Wind
09-12-2002 09:48 AM
Do you at least have IP Plus as your feature set?
09-12-2002 11:00 PM
Yes,
I have IP/VOX PLUS. Strange isn't it? Does the slot matter in which I installed the VIC 2b-NT/TE? It's in slot 1.
Rob
09-14-2002 04:46 AM
I have a similar problem. The voice-port command is missing. I can set up my dial-peers. I can set up the PRI. I can set up the MGCP stuff. But I can't configure the actual voice-ports.
This is my first attempt at a MGCP gateway. Can anyone give me some guidance as to why the command be missing. I am using 12.2(11)T image name is c3640-is-mz.122-11.T.bin
09-17-2002 11:07 PM
I load an older version: 12.2(8)YM. For the cisco 1760 there's bug in it (according to Cisco).
Rob
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide