Issue with Media URL display in 4305G

[pankajb]

I can run a mpeg URL if it is posted in Media URL within DMP by clicking Start but if I try sending the same URL either through Startup URL or as a Job I get an error "Write enable the disc or try different folder."

[Tomas de Leon]

Pankjb,

What is the format of the Video Content?

What is the sample URL that you are using?

What DMS-DMP version are you running on the 4305G?

In 5.2,  There is a Startup "Media" & "Browser" URL.  For "video" content you need to use

the MEDIA URL.  I have tested and it works fine.

If this answers your question, Please take time to mark this

discussion answered & rate the response.

Thank You!

T.

[pankajb]

What is the format of the Video Content? MPEG.

What is the sample URL that you are using? http://10.1.10.10/test.mpeg

What DMS-DMP version are you running on the 4305G? 5.2

In 5.2,  There is a Startup "Media" & "Browser" URL.  For "video" content you need to use the MEDIA URL.  I have tested and it works fine.

Yes when I paste this url in Dispaly Actions --> Media URL and press Start works fine. But the same URL I try to submit using Go To URL it gives error "Write Protected". If I give the same as Startup URL in Media - no display.

[Tomas de Leon]

Please provide screenshots of the following screens from

the DMP-DM:

* Settings->Basic

* About->Hardware and Firmware Versions

You mention:

"But the same URL I try to submit using Go To URL it gives error "Write Protected"."

There is no "Go To URL" setting where are you seeing that?

thanks

T.