04-08-2005 03:13 AM - edited 03-15-2019 03:23 AM
Hello,
I have a callmanager 4.1 and a Cisco2611XM with a vic-2briNT/TE interface.
I Cannot get it working. The interfaces won't connect to the callmanager (get a not registered status at the callmanager)
Does anyone got it working ?
Regards,
Erik
04-09-2005 12:48 AM
Hi,
Please check what it shows when u give "sh ccm". It should show registered with ur CCM. Then also check with "debug mgcp packet". That will show whether it communicates with ccm or not. If these two shows registered then plug the ISDN circuit and it should show registered in CCM administration page.
04-12-2005 08:13 PM
Erik,
I believe the BRI application requires h.323 configuration. I have only used 3.3, but simply set the name of the device to the IP address and it will connect.
04-13-2005 01:58 PM
Erik,
which version of CM 4.1? This should be work with 4.12 sr1 or 4.1.3 and BRI EuroISDN (no QSIG or other).
There are still problems with announcement messages from pstn with BRI interfaces.
greetings
Mehmet
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide