07-22-2002 02:25 AM - edited 03-12-2019 08:00 PM
Can I get the no. of the active connections of C2600 with NM-HDV-1E1-30E via snmp ?
07-29-2002 09:00 AM
Since there has been no response to your post, it appears to be either too complex or too rare an issue for other forum members to assist you. If you don't get a suitable response to your post, you may wish to review our resources at the online Technical Assistance Center (http://www.cisco.com/tac) or speak with a TAC engineer. You can open a TAC case online at http://www.cisco.com/tac/caseopen
If anyone else in the forum has some advice, please reply to this thread.
Thank you for posting.
07-29-2002 10:08 AM
check this out
/usr/local/bin/snmpwalk $ip_number community -O qv .1.3.6.1.4.1.9.10.19.1.1.9.1.3
It sould work cause I wrote some scipts that used this command
but for some time I had no possibility to use it
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide