Phones must get the numbers for a particular range.

[renzil]

hi,

I have a block of 600 DID number which have been distributed as follows

HO - 1 to 299

BO-1 - 300 to 399

BO-2 - 400 to 599

Can I have this configured on the CM such that any ip phone meant for a particular location gets the DN from the specified range only. This is a centralised CM design.

Thanks

Brgds

Renzil

[thisisshanky]

I dont think, this can be done for auto registration, as you can only set one range of numbers, one partition for them to fall under System -> Cisco Callmanager page. I am not aware of another work around for this, unless somebody else has a better suggestion.

[thisisshanky]

Using TAPS might help, but again this will involve a lot of work.

http://www.cisco.com/en/US/products/sw/voicesw/ps556/products_user_guide_chapter09186a008011b50e.html