could someone help me out here? i've got three routers. one is an srst remote on a t1 wic1-dsu. one is home site in front of cm 4.0 on a t1 wic1-dsu. one is a remote voice on a 3mb/d 600kb up adsl atm wic. under heavy network traffic, windows 2000 ntfrs for example, the qos dies. they're all connected by ipsec 3des vpn tunnels. i have the qos pre-classify command in the clientmaps on all. here are the revelant commands. do i need something else?
remote srst:
class-map match-any Voice
match ip dscp cs5
match ip dscp cs6
!
!
policy-map h323
description Video QoS Queue
class Voice
priority 672
class class-default
fair-queue 64
!
interface Serial0/0
description Interface Conn Internet
ip access-group acl-inbound in
ip nat outside
service-policy output h323
encapsulation frame-relay IETF
crypto map clientmap
home router
class-map match-any Voice
match ip dscp cs5
match ip dscp cs6
!
!
policy-map h323
description Video QoS Queue
class Voice
priority 448
class class-default
fair-queue 64
interface Serial0/0
no ip address
service-policy output h323
encapsulation frame-relay IETF
service-module t1 timeslots 1-24
frame-relay lmi-type ansi
crypto map clientmap
remote voice on adsl
class-map match-any Voice
match ip dscp cs5
match ip dscp cs6
!
!
policy-map h323
description Video QoS Queue
class Voice
priority 448
class class-default
fair-queue 64
interface ATM1/0
description Interface connected to modem
no ip address
service-policy output h323
no atm ilmi-keepalive
pvc 0/35
encapsulation aal5snap
!
dsl operating-mode auto
crypto map clientmap
bridge-group 1
thanks for looking.