QSIG:inbound calls fail due to partitions

[ruben.montes]

Hello,

I have configured an MGCP QSIG (C2851 with 2xE1 and CCM4.1(3)) with an Ericsson MD110. All the calls to the PBX numbers from IP phones work fine.

The problem apperas when I try to call an IP phone from the PBX: I can only reach those phones which aren't assigned to any partition or CSS. When I change the partition, the result from a debug q931 is 'Unassigned/unallocated number' and I cannot reach the phone.

It is my first QSIG with MGCP and partitions so I assume it's a configuration issue related with partitions, but I don't know where to search...

I have followed the Cisco doc " Cisco Callmanager4.1-PBX Interoperability Ericsson MD-110" with no luck...

Thanks in advance;

Ruben

[david]

I have setup quite a lot of QSIG gateways against Siemens Hicom and Avaya G700. But never Ericsson MD110. Sounds like you have selected a wrong or no calling search space for inbound calls on the gateway page. This usually returns 'Unassigned/unallocated number'. Just a thought.

Dave