Buy or Renew
Buy or Renew
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation
336
Views
0
Helpful
2
Replies

Question for an Ericsson MD110 professional

dcharlier
Level 1
Level 1

‎09-19-2002 09:05 AM - edited ‎03-12-2019 08:51 PM

Hello,

following configuration

IP Phones <=> E1 <=> VG200 <=> E1 <=> MD110 <=> Ericsson

We have problems with ringback when calling to Ericsson Phones.

Is there a special command to give ringback ON THE ERICSSON MD110 to generate this ringback.

Software is BC09.

Many thanks in advance !!!

Labels:
0 Helpful
2 Replies 2

msmith
Level 1
Level 1

‎09-19-2002 02:03 PM

dcharlier: are you using MGCP or H323? We have a near same setup, except we run a T1 tie line between our Cisco and Ericsson BC09 and use H323. Below is the dial-peer on the VG200:

dial-peer voice 100 pots

preference 3

destination-pattern [1-7]...

progress_ind alert enable 8

progress_ind progress enable 8

progress_ind connect enable 8

port 1/0:23

forward-digits all

You can email me direct if you wish. Good luck marc

0 Helpful

dcharlier
Level 1
Level 1
In response to msmith

‎09-19-2002 09:51 PM

Hello Marc,

we tried as well with MGCP as with H323. Same results.

Greetings

0 Helpful
Customers Also Viewed These Support Documents