04-11-2006 06:52 AM - edited 03-13-2019 12:52 PM
Has anyone had a similar problem using CCM4.1(3) with 7940 phones? When redial is pressed while on-hook, the speaker is turned on, dial tone is returned and template changes to show two softkeys "<<" and "New Call" but fails to dial last number. If the phone is taken off-hook before pressing redial, it works OK. This is not the case when using CCM3.3(5), pressing redial while on-hook works fine.
Have tried different phone loads from 7.0.2 to 8.0.1, all perform the same.
04-11-2006 09:38 AM
Hi Mark,
I am not using CCM 4.1.3 but have been doing some reading in preparation for an upcoming upgrade.Have you checked out the Softkey Template for the "On Hook" Call State? In 4.1.3 the templates can be configured differently based on the "Call State" of the phone. Have a look:
Configure Softkey Layout
The administrator can configure softkey sets for each call state for a nonstandard softkey template. When the administrator clicks the Configure Softkey Layout link from the Softkey Template Configuration window, the Softkey Layout Configuration window displays.
The Softkey Layout Configuration window contains the following fields:
Call statesLists the different call states of a Cisco IP Phone. You cannot add, update, or delete call states. The highlighted call state indicates the chosen call state and the softkeys that are available for that call state. Table 40-4 lists the call states.
Table 40-4 Call States
Call State Description
Connected
Displays when call is connected
Connected Conference
Consultation call for conference in connected call state
Connected Transfer
Consultation call for transfer in connected call state
Digits After First
Off-hook call state after user enters the first digit
Off Hook
Dial tone presented to phone
Off Hook With Feature
Off-hook call state for transfer or conference consultation call
On Hold
Call on hold
On Hook
Displays when no call exists for that phone
Remote In Use
Another device that shares the same line uses call.
Ring In
Call received and ringing
Ring Out
Call initiated and the destination ringing
Unselected softkeysLists softkeys that are associated with a call state. This field lists the unselected, optional softkeys when the call state is highlighted. The softkeys that are listed in this field get added to the chosen softkeys field by using the right arrows. You can add the Undefined softkey more than once in the chosen softkey list. Choosing Undefined results in a blank softkey on the Cisco IP Phone.
Selected softkeysLists softkeys that are associated with the chosen call state. This field lists the chosen softkeys when the call state is highlighted. The maximum number of softkeys in this field cannot exceed 16.
From this doc:
Hope this helps!
Rob
Please remember to rate helpful posts..........
04-17-2006 02:55 AM
On Callmanager 4.1(3)Sr3a redial softkey works fine in both cases - on-hook and off-hook
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide