02-03-2003 10:22 AM - edited 03-12-2019 10:32 PM
Could you please to help me to find out if I can use two or several 7940/7960 WITHOUT any SIP-proxy server?
02-10-2003 08:39 AM
Configure each Cisco7940/7960 SIP IP Phone to point to the other Cisco7940/7960 SIP IP Phone for the line_x proxy address settings. Also, make sure the proxy registeration is disabled. The phone configuration can be performed manually or by downloading the phone specific configuration files via tftp.
05-13-2003 12:37 PM
Hello,
I was wondering if you had any luck with getting this configuration to work? I have two 7960 phones running 4.2 and when configured for a point-to-point call as stated above, I get an immediate busy signal. Any thoughts would be appreciated.
thanks
todd
05-19-2003 05:24 AM
Check the following thread, I covered the same issue here:
Capturing "debug sip-messages" from the phone can be a very helpful troubleshooting tool. Be sure to enable telnet access to the phone first.
Regards,
Clay
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide