10-15-2006 08:57 PM - edited 03-13-2019 03:24 PM
Hi,
Have the following configuration for SRST router with an E1
dial-peer voice 10 pots
incoming called-number .
direct-inward-dial
port 0/3/0:15
!
dial-peer voice 100 pots
destination-pattern 0T
port 0/3/0:15
!
dial-peer voice 2000 voip
preference 1
destination-pattern 777..
progress_ind setup enable 3
progress_ind progress enable 8
translate-outgoing calling 1
voice-class codec 10
voice-class h323 10
session target ipv4:172.16.x.x
dtmf-relay cisco-rtp h245-signal h245-alphanumeric
ip qos dscp cs5 media
no vad
!
dial-peer voice 2001 voip
preference 2
destination-pattern 777..
progress_ind setup enable 3
progress_ind progress enable 8
translate-outgoing calling 1
voice-class codec 10
voice-class h323 10
session target ipv4:172.16.x.y
dtmf-relay cisco-rtp h245-signal h245-alphanumeric
ip qos dscp cs5 media
no vad
!
no dial-peer outbound status-check pots
num-exp 08666777.. 777..
num-exp 8666777.. 777..
num-exp 666777.. 777..
!
!
!
call-manager-fallback
max-conferences 4 gain -6
timeouts interdigit 5
ip source-address 172.17.z.x port 2000
max-ephones 168
max-dn 168 dual-line
When the phones register with the SRST users can make outgoing calls but incomming calls do not work.
At what point when the number comes in via pots does it hand off to the CCM FallBack to match the registered extensions? It matches the VoIP Dial peers ok so is there a preference of them over the ccm fallback?
Thanks
10-15-2006 11:41 PM
Can you please send the debug isdn q931, sh run and the debug voip ccapi inout
thanks
10-16-2006 03:21 AM
Hi,
What are the SRST User extension numbers, how many digits long are they ?
It could simply be a num-exp problem.
10-20-2006 06:44 AM
Hi ,
In your Call-manager-fallback , you must set also the expression :
dialplan-pattern 1 8666777.. extension-length 5 no-reg
So that you can link the internal number with the external .
Hope that It will help you ....
Olivier
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide