STUN SERVER SETTING CISCO 7940

[hmjgriffon]

Okay I finally got this 7940 set up, but from what I can tell I need to be able to set it up to use a stun server for the gizmo SIP phone service. I ran wireshark and made calls with the gizmo software and it deffinately uses stun. I have the newest firmware I could find on the phone and no stun settings, are you just not supposed to use stun with these phones? my firmware settings are

Application Load ID

P03-08-6-00

Boot Load ID

PC030301

DSP Load ID

4.0(2.0)[A0]

am I just hosed?

[paolo bevilacqua]

Sorry, cisco phones don't support stun.

What you can do, is to configure nat_enable and nat_address ip in the config file. look at:

http://www.voip-info.org/wiki/view/cisco+mass+deployment

hope this helps, please rate post if it does!