Synthetic Transactions

[vk]

Hi could you share some info how these tests are configured

I know how to do it in VHM (at least where to find it) but what has to be done in CCM when I use for example simulated IP Phones ?

Phone Registration

Off Hook

Empty Call

End to End Call

Phone to Gateway Call

Phone to Conference Bridge Call

In the phone to gateway call test would it be possible to call from an local IP Phone to an local IP Phone using a route pattern that is forwarded through the gateway to the PSTN and the PSTN sends it back (I have Cat 6509 with 6608 and no FXS module)

Phone Registration

Off Hook

Empty Call

End to End Call

Phone to Gateway Call

Phone to Conference Bridge Call

Thanks,

Vidir

[ciscomoderator]

Often times complex troubleshooting issues are best addressed in an interactive session with one of our trained technical assistance engineers. While other forum users may be able to help, it’s often difficult to do so for this type of issue.

To utilize the resources at our Technical Assistance Center, please visit http://www.cisco.com/tac and to open a case with one of our TAC engineers, visit http://www.cisco.com/tac/caseopen

If anyone else in the forum has some advice, please reply to this thread.

Thank you for posting.