VOIP Sample config

[fmatrine]

Dear All,

I have a scenario where i am using 2 routers each having 2 port FXS card. I am connecting both the routers back to back over ethernet port.

I want to connect FXS card on either end to PBX and place a voice call through PBX (I am not having E&M card to interface with PBX).

I would like to have a sample config for the same.

Router A having FXS card connected to PBX

Router B having FXS card conncted to PBX

Router A and Router B are connected back to back over ethernet interface over Cross UTP cable.

Sample configuration for interfacing FXS to PBX is required

[pcantore]

Lots of samples on CCO, here are a couple:-

http://www.cisco.com/en/US/tech/tk652/tk701/technologies_configuration_example09186a00800afd65.shtml

http://www.cisco.com/en/US/tech/tk652/tk701/technologies_configuration_example09186a008009431b.shtml

Remember that if you have FXS ports, your PBX must have FXO interfaces if you do not wish to use some form of converter for signalling conversion.