cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Announcements

815
Views
0
Helpful
1
Replies

My NAM is no capturing anymore

Hi,

I have a Network Analysed Module in a switch, and strangly it is not capturing anymore. It´s meet the system requierment and it was working just fine 2 weeks ago, i have tried to clean up old capture, same issue. Error message i got is: "please check the NAM snmp to the switch", when i´m in the GUI in setup --> Switch parameters.

Does someone knows anything about this ?

Regards

1 REPLY 1

Hi,

I have a Network Analysed Module in a switch, and strangly it is not capturing anymore. It´s meet the system requierment and it was working just fine 2 weeks ago, i have tried to clean up old capture, same issue. Error message i got is: "please check the NAM snmp to the switch", when i´m in the GUI in setup --> Switch parameters.

Does someone knows anything about this ?

Regards

Hi,

Try to check the parameter Wrap when Full and try capture and is snmp configuration is configured reagrding the switch community string in NAM.

http://www.cisco.com/en/US/products/sw/cscowork/ps2803/products_tech_note09186a00800948b5.shtml#topic1

Hope to Help !!

Ganesh.H

Remember to rate the helpful post

Content for Community-Ad