WHi,
Good morning !! Would someone help me to clarify the questions below ? Thank you... My understanding is that the traffic on underlay would match the sum of traffic going via overlay. But when i analyzed the Netflow report in SolarWinds, it is not the case so i wanted to clarify whether my understating is correct. Let's take an example..
Physical INTERNET interface - Gi0/0/4 (Underlay interface) - Capacity is 500 Mb/s
Gi0/0/4 BW Usage – 300 Mb/s (Rx) at Specific time.
Network ManagementNetwork Management
At the same time, the Netflow usage on each individual interface as below.
Tunn 1 (DMVPN) – 2.9 Mb/s (Rx)
Tunn 10 (GRE to PROXY) – 104.7 Mb/s (Rx)
Gi0/0/4 (DIA Traffic) – 152.2 Mb/s (Rx)
so far Total = 260 Mb/s (apx) and the remaining around 40 Mb/s (300-260) is consumed by Guest.
My question is that the underlay or physical interface (gi0/0/4) BW usage (300 Mb/s) does not match the Netflow traffic on the same interface whereas it shows only 152.2 Mb/s.,
Doesn't it not sum up the overlay traffic of DMVPN/GRE tunnel and show the aggregate value under physical interface netflow report, if not may i know why ?
