it is the first time that i install and configure a Nexus 1010.
After unpackaging, i have upgrade the BIOS, CMC and Firmware of the nexus 1010 (like a classical C-serie server)
The CIMC 's @ip is 10.10.0.100 ; I have connected the 10/100 Ethernet CIMC management port to my OOB network where we have all OOB interfaces from Nx7k and Nx5k.
Now i would want configure the Nx1010 in the topology "uplink type 3".
port 1 and 2 : mangement Vlan
port 3 to 6 : Control/packt Vlan and Data Vlan.
In the setup wizard, we have to configure the int Mgmt0 of Nx 1010.
In which network must be the Mgmt0 ; i am confused and mix up :
- CIMC mgmt from the C-series server
- mgmt0 int from nexus 1010 : by which physical interface goes throught this traffic : via "10/100 Ethernet CIMC management port" or via "Management vlan" ???
- Vlan management : this Vlan will allow to manager the VSB VSM-1 et VSM-2....
The Vlan management must not be the OOB network, must it ?
It is not clear for my mind ; i mix up all this mgmt
please help me !!!
many thank in advance.
NB : All the devices in our DC (Nx5k and Nx5K/Nx2K) have two management interface :
1 - OOB management via the pysical OOB port
2 - Inb management via a dedicated Vlan ; each device have 1 @ip in this Vlan (even the L2 Nx7k (without M1 card) via the cli "management")
How could i have the these mgmt for Nexus 1010 / CIMC / VSM ???
Last question : in order to upgrade the nx 1010, then download the nexus-1000v*.iso to bootflash:repository, which network/mgmt i have to used ???