I purchased a new ap1041n access point. It's the first Cisco I've tried to configure in a long time. I'm trying to get the 802.11n working but it seems to be stuck in 802.11G since I can only get it to go up to 36mb. The radio says its running in mixed mode and I can't figure out if that means b/g or b/g/n. I ran the Express Setup and it didn't seem to help me. I'm hoping it's an easy fix. I posted the config below, if anyone can help me it would be greatly appreciated.
!
version 12.4
no service pad
service timestamps debug datetime msec
service timestamps log datetime msec
service password-encryption
!
hostname AP
!
logging rate-limit console 9
enable secret 5 $1$36ve$pm3oh52Ka.KyxGeMa9W7C1
!
no aaa new-model
ip domain name hyrule
!
!
dot11 syslog
!
dot11 ssid Test
authentication open
authentication key-management wpa
guest-mode
wpa-psk ascii 7 1521040F0B0B26253A3621361C2B1F0E04
no ids mfp client
!
!
!
username
username
!
!
ip ssh version 1
bridge irb
!
!
interface Dot11Radio0
no ip address
no ip route-cache
!
encryption mode ciphers aes-ccm tkip
!
ssid UNSC
!
antenna gain 0
speed basic-1.0 2.0 5.5 11.0 6.0 9.0 12.0 18.0 24.0 36.0 48.0 54.0 m0. m1. m2. m3. m4. m5. m6. m7. m8. m9. m10. m11. m12. m13. m14. m15.
station-role root
no dot11 extension aironet
bridge-group 1
bridge-group 1 subscriber-loop-control
bridge-group 1 block-unknown-source
no bridge-group 1 source-learning
no bridge-group 1 unicast-flooding
bridge-group 1 spanning-disabled
!
interface GigabitEthernet0
no ip address
no ip route-cache
duplex auto
speed auto
no keepalive
bridge-group 1
no bridge-group 1 source-learning
bridge-group 1 spanning-disabled
!
interface BVI1
ip address 10.10.0.251 255.255.255.0
no ip route-cache
!
ip default-gateway 10.10.0.1
ip http server
no ip http secure-server
ip http help-path http://www.cisco.com/warp/public/779/smbiz/prodconfig/help/eag
access-list 111 permit tcp any any neq telnet
bridge 1 route ip
!
!
!
line con 0
access-class 111 in
line vty 0 4
access-class 111 in
login local
!
end
