08-31-2006 08:16 AM - edited 03-03-2019 04:45 AM
I have a cisco 1750 router. I just got a wic-1enet card for it. the router meets all the requirements for the card, and the slot 0 ok led is on. when I log into the console port and do "show interfaces" all I get is the fast ethernet that is onboard, and loopback0. ethernet 0 doesn't show up in there. am I doing something wrong or is there something I can do to try and fix the problem?
08-31-2006 08:21 AM
Please do a show version and check if your ethernet card is listed there. If yes, then the router is recoznising the card and try to reseat it again and possibly a reload after that. Try shut and no shut on the interface as well.
If no, then check the hardware/software requirement of the card.
Regards,
-amit singh
08-31-2006 12:10 PM
Cisco Internetwork Operating System Software
IOS (tm) C1700 Software (C1700-BNR2Y-M), Version 12.0(5)XQ, EARLY DEPLOYMENT REL
EASE SOFTWARE (fc1)
TAC:Home:SW:IOS:Specials for info
Copyright (c) 1986-1999 by cisco Systems, Inc.
Compiled Mon 09-Aug-99 13:53 by rnapier
Image text-base: 0x80008088, data-base: 0x807A7458
ROM: System Bootstrap, Version 12.0(3)T, RELEASE SOFTWARE (fc1)
ROM: C1700 Software (C1700-BNR2Y-M), Version 12.0(5)XQ, EARLY DEPLOYMENT RELEASE
SOFTWARE (fc1)
it doesn't show the ethernet card in the "show version" results. from everything I've read, in the manual and online, it says it should support the card, but only in slot 0.
08-31-2006 12:36 PM
show diag gives me this:
Slot 0:
C1750 1FE VE Mainboard port adapter, 1 port
Port adapter is analyzed
Port adapter insertion time unknown
EEPROM contents at hardware discovery:
Hardware revision 5.2 Board revision C0
Serial number 2660151875 Part number 73-3743-05
Test history 0x0 RMA number 00-00-00
EEPROM format version 1
EEPROM contents (hex):
0x20: 01 C9 05 02 9E 8E B2 43 49 0E 9F 05 00 00 00 00
0x30: 60 00 00 04 00 00 00 00 00 00 00 00 00 00 00 00
WIC Slot 0:
Unknown WAN daughter card
Hardware revision 64.0 Board revision G0
Serial number 0960561920 Part number 130-18710-165
Test history 0x03 RMA number 66-65-48
Connector type PCI
EEPROM format version 4
EEPROM contents (hex):
0x20: 04 FF 40 00 39 41 03 00 82 49 16 A5 03 42 41 30
0x30: 80 00 00 00 00 02 02 C1 8B 56 4D 53 30 36 32 36
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide