Buy or Renew
Buy or Renew
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation
312
Views
4
Helpful
1
Replies

IOS loading Issue

JUNKSA_2
Level 1
Level 1

‎08-26-2006 04:47 AM - edited ‎03-03-2019 04:42 AM

Dear All:

I have a 7609 Router with SUP720 installed in module 5 and I have a CMM installed in module 1.

For Some reasons, bootflash image in the CMM module was corrupted and the CMM module is stuck in ROMMON mode.

I copied the bootflash image in the other CMM module installed in module 2 and I uploaded to my tftp server.

The instruction what I get from the CCO site is for catalyst 6509 switches and not for 7609. I tried different trial and error but I failed.

How can I load the image from SUP720 going to the bootflash of the fatal CMM module.

Anybody can give me the solution.

Thanks.

Labels:
0 Helpful
1 Reply 1

ebreniz
Level 6
Level 6

‎08-31-2006 10:12 AM

check out the following link on Disaster Recovery for CMM Software Upgrades, hope this helps :

http://www.cisco.com/en/US/partner/products/hw/switches/ps708/prod_module_install_config_guide09186a008014f5b1.html#wp278012

Customers Also Viewed These Support Documents

Review Cisco Networking for a $25 gift card