11-11-2003 10:53 PM - edited 03-02-2019 11:38 AM
Hi All
I have 1 2612 with a tokenring lan on one side and a ethernet on the other side. I have tried to follow several examples from the cisco site without any sucsess. Can anyone help me? This is my config so far, what am I missing here?
no service single-slot-reload-enable
service timestamps debug uptime
service timestamps log uptime
no service password-encryption
!
hostname Router
!
enable secret 5 ****************************
enable password ******
!
!
!
!
!
ip subnet-zero
!
!
!
!
!
source-bridge ring-group 10
source-bridge transparent 10 11 1 1
!
interface Ethernet0/0
no ip address
half-duplex
bridge-group 1
!
interface TokenRing0/0
no ip address
ring-speed 16
source-bridge 1 1 10
source-bridge spanning
!
ip classless
ip http server
!
dialer-list 1 protocol ip permit
dialer-list 1 protocol ipx permit
!
bridge 1 protocol ieee
!
line con 0
line aux 0
line vty 0 4
password ******
login
!
end
Rgds,
Svein
11-12-2003 04:05 AM
Hi,
Which protocols do you try to bridge - layer 2 or/and layer 3 protocols (ip/ipx).
If you bridging ip, you can try irb with bitswapping of layer 3. Be aware of RIF.
Hope this gives you some ideas.
Brg,
Steinar
11-12-2003 08:10 AM
There should a command along the lines of
bridge 1 bitswap-layer3-addresses
11-12-2003 10:48 PM
Hi
Thanks for the help, but it still doesnt work. From our 2612 and to the Tokenring side we have a IBM8272 Tokenring Switch which everything is connected to. So I'm wondering if there is anything that I'll have to do in this switch as well?.
BTW i have added these lines in global mode:
bridge 1 bitswap-layer3-addresses
bridge irb
/Svein
11-17-2003 02:08 AM
Hi,
Sorry for delayed answer.
It is not good to have both srtlb and irb since it could generate a loop.
You should try to use a sniffer to see what is happening.
Steinar.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide