09-16-2005 08:22 AM - edited 03-03-2019 12:04 AM
Hi guys, ive had problems with one of these in the past getting it to route but now i have to get it working. Can you tell me to get it routing to different subnets (one per port for 3 ports) is the following all i need?
interface FastEthernet1
ip address 192.168.20.1 255.255.255.0
no ip directed-broadcast
!
interface FastEthernet3
ip address 192.168.30.1 255.255.255.0
no ip directed-broadcast
!
interface FastEthernet3
ip address 192.168.40.1 255.255.255.0
no ip directed-broadcast
!
interface BVI1
ip address 10.11.1.20 255.255.0.0
no ip directed-broadcast
!
router eigrp 10
network 10.0.0.0
network 192.168.20.0
network 192.168.30.0
network 192.168.40.0
!
ip default-gateway 10.11.1.1
ip classless
ip route 0.0.0.0 0.0.0.0 10.11.1.1
!
the BVI int is the management subnet and all ports connected to bridge group 1 are part of this (its our network)
the other ports are for 3rd parties thus i need to create different subnets for them.
09-19-2005 08:02 AM
Hi cro9uk,
Looks sufficient, although you could turn off EIGRP if it is not needed.
You can test your configuration by pinging and tracerouting from each LAN with a laptop to each other LAN.
Regards,
Thomas
09-19-2005 01:18 PM
Hi
Remember to enable routing with the 'ip routing' command.
Regards.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide