08-19-2005 07:46 AM - edited 03-02-2019 11:46 PM
I have a 24port 2950 Switch
every time I boot it I get
2950 Boot Loader (C2950-HBOOT-M) Version 12.1(11r)EA1, RELEASE SOFTWARE (fc1)
Compiled Mon 22-Jul-02 17:18 by antonino
WS-C2950-24 starting...
Invalid parameter block -- no mac address available.
Xmodem file system is available.
This extract is from the boot process, prior to the flash: file system initialising.
Once the switch has booted, and issue a show ver, the end says;
Invalid parameter block -- no serial number or mac address available.
Configuration register is 0xF
So far, to cure this I have tried:
Edit of the env_vars file
copy of env_vars from an identical 2950 with same ios
format of flash:
reload at that point so there is nothing, reload an IOS over xmodem (fun) and then start from scratch only to get the same error.
Any ideas on this ?
Solved! Go to Solution.
08-19-2005 07:57 AM
You have a hardware failure and the switch will need to be replaced. Open a service request with TAC if you have a service contract on this device.
08-19-2005 07:57 AM
You have a hardware failure and the switch will need to be replaced. Open a service request with TAC if you have a service contract on this device.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide