I have a 3640 fastethernet problem, the interface always appeared to be disabled, when I enter 'no shutdown' at the interface configuration mode, it can not work. Below is some of the command display result I entered. Hope someone can help me to resolve this problem.
Router#sh diag
Slot 0:
Sync/Async Port adapter, 8 ports
Port adapter is analyzed
Port adapter insertion time unknown
EEPROM contents at hardware discovery:
Hardware revision 1.0 Board revision E0
Serial number 13847436 Part number 800-01225-02
Test history 0x0 RMA number 00-00-00
EEPROM format version 1
EEPROM contents (hex):
0x20: 01 25 01 00 00 D3 4B 8C 50 04 C9 02 00 00 00 00
0x30: 70 09 E6 00 99 04 16 17 FF FF FF FF FF FF FF FF
Slot 1:
Mueslix-4T Port adapter, 4 ports
Port adapter is analyzed
Port adapter insertion time unknown
EEPROM contents at hardware discovery:
Hardware revision 1.1 Board revision D0
Serial number 13856996 Part number 800-02314-02
Test history 0x0 RMA number 00-00-00
EEPROM format version 1
EEPROM contents (hex):
0x20: 01 54 01 01 00 D3 70 E4 50 09 0A 02 00 00 00 00
0x30: 68 00 00 00 99 04 20 00 00 05 FF FF FF FF FF FF
Slot 2:
Mueslix-4T Port adapter, 4 ports
Port adapter is analyzed
Port adapter insertion time unknown
EEPROM contents at hardware discovery:
Hardware revision 1.1 Board revision D0
Serial number 13856978 Part number 800-02314-02
Test history 0x0 RMA number 00-00-00
EEPROM format version 1
EEPROM contents (hex):
0x20: 01 54 01 01 00 D3 70 D2 50 09 0A 02 00 00 00 00
0x30: 68 00 00 00 99 04 20 00 00 05 FF FF FF FF FF FF
Slot 3:
Fast-ethernet Port adapter, 1 port
Port adapter is disabled
Port adapter insertion time unknown
EEPROM contents at hardware discovery:
Hardware revision 1.0 Board revision D0
Serial number 14220615 Part number 800-03490-02
Test history 0x0 RMA number 00-00-00
EEPROM format version 1
EEPROM contents (hex):
0x20: 01 44 01 00 00 D8 FD 47 50 0D A2 02 00 00 00 00
0x30: 68 00 00 00 99 04 28 00 FF FF FF FF FF FF FF FF
Router#sh ver
Cisco Internetwork Operating System Software
IOS (tm) 3600 Software (C3640-I-M), Version 12.1(2)T, RELEASE SOFTWARE (fc1)
Copyright (c) 1986-2000 by cisco Systems, Inc.
Compiled Tue 16-May-00 12:26 by ccai
Image text-base: 0x600088F0, data-base: 0x60924000
ROM: System Bootstrap, Version 11.1(20)AA1, EARLY DEPLOYMENT RELEASE SOFTWARE (fc1)
Router uptime is 11 minutes
System returned to ROM by reload
System image file is "flash:c3640-i-mz.121-2.T"
cisco 3640 (R4700) processor (revision 0x00) with 61440K/4096K bytes of memory.
Processor board ID 13893034
R4700 CPU at 100Mhz, Implementation 33, Rev 1.0
Bridging software.
X.25 software, Version 3.0.0.
8 Serial network interface(s)
8 Low-speed serial(sync/async) network interface(s)
DRAM configuration is 64 bits wide with parity disabled.
125K bytes of non-volatile configuration memory.
16384K bytes of processor board System flash (Read/Write)
Configuration register is 0x2102
Router#sh int f3/0
FastEthernet3/0 is administratively down, line protocol is down
Hardware is AmdFE, address is 00d0.5864.ba70 (bia 00d0.5864.ba70)
Internet address is 192.168.0.249/24
MTU 1500 bytes, BW 100000 Kbit, DLY 100 usec,
reliability 255/255, txload 1/255, rxload 1/255
Encapsulation ARPA, loopback not set
Keepalive set (10 sec)
Unknown duplex, Unknown Speed, 100BaseTX/FX
ARP type: ARPA, ARP Timeout 04:00:00
Last input never, output never, output hang never
Last clearing of "show interface" counters never
Queueing strategy: fifo
Output queue 0/40, 0 drops; input queue 0/75, 0 drops
5 minute input rate 0 bits/sec, 0 packets/sec
5 minute output rate 0 bits/sec, 0 packets/sec
0 packets input, 0 bytes
Received 0 broadcasts, 0 runts, 0 giants, 0 throttles
0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored
0 watchdog
0 input packets with dribble condition detected
0 packets output, 0 bytes, 0 underruns
0 output errors, 0 collisions, 1 interface resets
0 babbles, 0 late collision, 0 deferred
0 lost carrier, 0 no carrier
0 output buffer failures, 0 output buffers swapped out
Router#conf t
Enter configuration commands, one per line. End with CNTL/Z.
Router(config)#int f3/0
Router(config-if)#no shutdown
Router(config-if)#end
Router#sh int f3/0
FastEthernet3/0 is administratively down, line protocol is down
Hardware is AmdFE, address is 00d0.5864.ba70 (bia 00d0.5864.ba70)
Internet address is 192.168.0.249/24
MTU 1500 bytes, BW 100000 Kbit, DLY 100 usec,
reliability 255/255, txload 1/255, rxload 1/255
Encapsulation ARPA, loopback not set
Keepalive set (10 sec)
Unknown duplex, Unknown Speed, 100BaseTX/FX
ARP type: ARPA, ARP Timeout 04:00:00
Last input never, output never, output hang never
Last clearing of "show interface" counters never
Queueing strategy: fifo
Output queue 0/40, 0 drops; input queue 0/75, 0 drops
5 minute input rate 0 bits/sec, 0 packets/sec
5 minute output rate 0 bits/sec, 0 packets/sec
0 packets input, 0 bytes
Received 0 broadcasts, 0 runts, 0 giants, 0 throttles
0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored
0 watchdog
If you have any others want to know ,please feel free to contact me at zhijunguo@vip.sina.com.
Thank you!
Guozhijun
